About this Boat
The Farrier F-33 is a technically advanced trimaran design built to very high standards. It is a fast and comfortable cruiser, fully trailerable but yet has ocean-going capability. The F-33 trailers at 9' 6" wide, which will require a simple yearly permit in most areas. Advanced design construction techniques are employed to ensure the highest strength to weight ratio and efficient hull shapes, making the F-33 an exhilarating performer and among the fastest in its class to be found anywhere.
Grey Hound was built in Australia by Keals Marine under the strict control of Ian Farrier himself and delivered via a container to the USA. Her maiden launch was in May 2005 with Ian Farrier present.
Check out the link below for delivery and launching pictures.
Grey Hound is probably the best equipped F33 for cruising and the occasional beer can race. Cruise in comfort but also enjoy speeds above 20 knots without any anxiety. The Generation 3 floats and beams keep the boat dry and safe. She boat has been sailed seasonally on an inland lake in Illinois for the last 7 years.
- Keel: Centerboard
- LOA: 33 ft
- Beam: 23.42 ft
- Maximum Draft:
- Maximum Displacement:
- Dry Weight:
Additional DetailsConstruction and technical Details
The F-33 design utilizes an improved Farrier Folding System with an integrated structural support system. Beams are shaped to direct any water down and under the boat, while also being slim and high at outer ends for less drag. The inner beam end to main hull connections are external, for easier setup and maintenance, which also allows shorter beams for a lower trailering height, and resulting in reduced wind resistance when on the road. Trailering width is 9' 6" (2.9m).
The F-33 has epoxy foam core hulls, carbon/glass fiber beams, all extensively vacuum bagged, and finished with a two pack linear polyurethane (LP) finish.
The F-33 float bow tips are designed to be sacrificial, and will absorb any float bow heavy impact, to help prevent more extensive damage that can result from collisions. The floats remain watertight, and still sailable in most collision situations.
ockpit seating area is high to give better visibility forward, and more room underneath, but still low enough so that one still has a good sense of security from sitting more in the boat rather than on it.
Carbon Fiber Bow Tube and Chainplates
Carbon Fiber Folding Strut Anchors - no brackets or bolts
Dagger type, Kickup Rudder - custom aftermarket purchase from Ian Farrier
Also included with with the boat is a regular shorter daggerboard and regular kick up cassette rudder
Farrier Folding SystemTM - high tensile CNC machined aluminum struts, with over size Type 316 stainless steel pins and custom high strength plastic bushings.Double Bolted Forward Beams - both forward beams have twin hold down bolts.
L.O.A................................. 33' (10.06m)
B.O.A................................. 23' 5" (7.14m)
L.W.L................................. 31' 4" (9.55m)
Folded beam........................9' 6" (2.9m)
Approx. bare weight ...........3,500 (less mast and boom)
Load Carrying Capacity ......3300lbs
F-33 rotating mast ................44.7' (13.62m) aluminum from Ballenger Spar
Mast height above waterline...~50ft
F-33 sail area (main & jib).... 673sq.ft (62.56sq.m.)
Stability ............................... 59,000 ft.lbs
Draft (board up).....................22 ins
Draft (board down)............... 7'
Interior Headroom .................6' 2"
Auxiliary............................... Honda Saildrive 280 (12.5hp)
Water ....................................26 gallons
Holding tank..........................26 gallons
Cockpit length.......................9 ft 10 in
Custom interior upholstery (see pictures)
Stainless Steel Galley Sink
SMEV -pressurized - 26 US gals. water tank
Two burner SMEV propane Stove
Hanging locker on port side
Head Compartment - stainless sink with pressure water with Privacy Curtain
Head - Lavac - manual
Side Ventilation Hatch in Head Area - and two in the v-berth
Custom galley add-ons for knives, plates and pantry
Y-valve for direct pump out and special turn-couple line assembly installed
Ice box located under seat in dinette
10 lb horizontal propane tank in lazarette
Frontrunner liner in dinette and v-berth area for a warmer atmosphere
Ample storage under v-berth and all interior cushions
(2) fire extinguishers
Fresh water and dark water gauges
Reading light in main salon and two in the v-berth
: Two Part Acrylic paint - Sterling - Hull is Snow White and non-skid is Matterhorn white
Self-Draining Anchor Well: incorporates two closeable interior hatches.
Composite Bow Wing - increases bow net size, and provides anchor mounting area clear of headsails
Bow Nets : Heavy duty open mesh with UV protective coating from Sunrise Nets
Wing Nets: Heavy duty compact PVC mesh from Sunrise Nets
Companionway Hatch Boards - in tinted polycarbonate and also custom superlight boards made from Coosa Board
Main Cabin Side Windows - in tinted acrylic
Self-Draining Cockpit - With storage lockers both sides Two Float Deck Hatches - min. 15 x 20" (380 x 510mm)
One Emergency Access Hatch - in the closet area
Safety Gear Compartment - in hull side under the cockpit
Stainless Steel Bow and Stern Pulpits
(2) Andersen 46 Two Speed Primary Jib Sheet Winche
Andersen 40ST Two Speed Self-tailing Halyard Winch
Spinlock XCS Rope Clutches (7 each)
Harken 'Big Boat' Roller Bearing Traveler System
Harken Windward Sheeting Traveler Car Harken 12:1 Mainsheet System
Pull up Daggerboard With Flush control lines - custom carbon daggerboard built by Turnpoint Design- 7' max. draft
Compass - Suunto - mounted in cockpit
Dodger and Bimini replaced 2018 includes side curtains and sunscreens
6 gallon fuel tank in port lazarette with 2 gallon spare tank
Custom folding tiller arm to get it out of the cockpit when not in use
(2) tiller extensions
(1) automatic bilge pump
(1) manual bilge pump in cockpit
(1) portable manual bilge pump
Rotating wing Mast, grey anodized aluminum- 44.7' long, Ballenger Spars with masthead VHF antennae
Boom - anodized aluminum from Ballenger Spar with reefing lines
Mast Raising Pole
Mast Raising wires
Colligo Synthetic Side Stays
Steaming and Deck lights - deck plug fits into flush recess in deck
Required Sheets and Lines - for main, jib, screecher and Code 0
Main halyard, 2:1 with Equiplite shackle
2018 new 9mm Dyform headstay inside jib foil
2.5mm lazy jacks
custom made radar detector
Fully Battened Mainsail Schurr Sails 2018
Jib - Dacron, Mack Sails - July 2009
Screacher – Schurr Sails, black, 2017 with Facnor continous line furler
Code 0 - Calvert Sails, with Facnor continous line furler
Spinnaker with Colligo Hlf Topdown furler
Spinnaker Sock ATN 2017, hardly used
12V electrical system with Circuit Breaker Switch Panel
, Battery Test Meter, (2) Optima 12V gel batteries (130AH)
(3)12v Accessory Outlets
Morningstar charge controller with remote meter
110 watt solar panel over the bimini
additional reading lights in main cabin and v-berth
All lights LED
Instruments VHF radio - Icom 502 with remote mike in the cockpit. and external speaker Icom Stereo – new in 2018, CD Pandora
Phone attachment with 2 PolyPlanar speaker in main cabin and two in the cockpit Autopilot- Raymarine ST1000 - new November 2011
Autohelm - wireless remote for autopilot
Fireboy - SA-2 fume detector with auto shutoff for propane
Tactick wireless Depth and Speed, Wind, Rotator, Masthead, compass, all wireless, with additional remote
Honda 12.5 h.p. Saildrive 280Trailer
Trailer - Great Lakes Trailer Aluminum I-beam, dual axle, with stainless steel disk brakes (new August 2011)
Trailer Spare wheel - two
all tie down lines, mast stands and pads included for trailering
Cockpit Cushions: Waterproof and tailor made for cockpit.
Boarding Ladder: transom - custom made stainlessBottom Paint: Petit Vivid
Anchors: 1 Spade A-80 aluminum with 30 feet of chain and 150' of 1/2 inch braid line
Dock line Package: Including four fenders and 4 dock lines
man-overboard light & life sling
Gas heated hot cockpit shower
Electric Winch Buddy refurbished with new battery and new brushless motor 2018
4 tall boat stands and 2 small boat stands for lifting boat off trailer for yearly maintenance
Windcraft offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
This listing is courtesy of the BoatWizard MLS and may be centrally listed with another broker. It is offered as a convenience by this broker/dealer to its clients and is not intended to convey representation of a particular vessel.